No announcement yet.

Which PIC16F-compatible IDE and compiler should I choose?

  • Filter
  • Time
  • Show
Clear All
new posts

  • Which PIC16F-compatible IDE and compiler should I choose?

    This is going to be a bit long as I wanted to cover all the obvious questions before they arise, give a rationale to some of my thinking, and prove I've done my groundwork! If time is short, skip down to the tl;dr section to get to the meat. The banner above also says this looks like a subjective post, so I'm going to expand the post a bit to narrow down exactly what it is I want to achieve.

    I've had a really good look around stackexchange and there are similar-ish questions to mine, and I found the question Starting out PIC Programming useful but most were asked and answered before the new release of MPLAB X which is now based around the open source NetBeans IDE which is quite a change, so might tilt the balance.

    Background: I bought an Arduino recently and having never done MCU fiddling before, and my programming knowledge limited to PHP, I was quite pleased with the results.

    There's a few "fun" things I want to do to start with to get going before the
    PIC16F690-E/P,Microchip Technology,20-DIP (0.300", 7.62mm),Embedded - Microcontrollers,PIC16F690-E/P Datasheet PDF

  • #2

    i'm surprised your stealth adds are tolerated here too

    your post is a cut and paste of this stack post 5 years ago ,
    Last edited by richard; 03-09-2018, 01:38 PM. Reason: more info