Announcement

Collapse
No announcement yet.

What have I done?!

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • What have I done?!

    I upgrade to PBP3, Microcode Studio and the Melabs Beta programmer software a couple of months ago and got everything working smooth. I'm using the U2 USB programmer.

    I was programming some chips the other day and I closed Microcode Studio while a chip was about half way through programming and for some reason it closed the programmer software too. Since then, I can't get a program to work. The chips that I programmed before then work, but the exact program on chips programmed after that don't work. It compiles successfully and the programming software shows that it programmed successfully and the code very is successful, but when I put the chip in the circuit...nothing happens.

    I reinstalled PBP3, MPLABS, Microcode studio and the programmer software and flashed the programmer again, and of course rebooted too, and still the same results. I'm stumped?
    Gary

  • #2
    Try resetting the options in the meProg software. In meProg:

    Options > More Options > Set Options to Defaults...
    Charles Leo
    ME Labs, Inc.
    http://melabs.com

    Comment


    • #3
      WHOOHOOO! That did it! Thanks Charles!
      Gary

      Comment

      Working...
      X